Gutter Installation – How to Do it Yourself

You’ll need a few key pieces of equipment for gutter installation, including a ladder that you can safely use on your roof. You’ll also need tin snips to cut the gutter sections to their required lengths, as well as gutter sealant and end caps. Lastly, you’ll need a downspout to direct rainwater away from your home. Source:

Tips for Choosing the Best Online Dispensary for Bulk Weed in Canada

Begin by setting a sheet of plywood on sawhorses to serve as a workstation for your gutter project. Once you’ve decided where to start, set one of the gutter sections on the plywood and trace around it with a pencil. This will help you mark the high and low points of the slope line you’ll be following later.

Next, assemble the K-style fascia brackets by slipping their hooks into the holes in the ends of the gutter sections. Then, use a drill to pre-drill each spot where you’ll attach the brackets to the fascia board. Finally, drive screws into each of these spots to secure the brackets.

Repeat this process with the other side of the gutter and its downspout outlet. Then, use a drill to make holes for the downspout outlets and screw or rivet each one in place. You can either splice the gutter sections together using a slip coupling like those used on inside corner fittings or you can overlap them. Overlapping tends to look better and will keep water flowing in the right direction. Before you do this, however, squeeze (or “crimp”) the ends of each short section of gutter with a gutter crimper to ensure it fits inside the next elbow or downspout outlet.

Leave a Reply

Your email address will not be published. Required fields are marked *